Antminers Dust Cleaning Instructions


  • When you find the case of the antminer is dusty, please shut down and clean.
  • When the Antminer is not running properly during the inspection, that might because of the dust or other debris attached on the hash board which affect the heat dissipation.
  • Please clean the dust regularly. We recommend do it once a month.
  • The machine must be turned off during cleaning.
  • If the air gun cannot blow out the dust because of the high humidity, you need to remove the fan and brush out the stubborn dust.


Equipment: Air Compressor + Air Gun

Air Pressure Range: 0.7 +/- 0.05 MPa


Cleaning method:

  1. Softly blow the front and rear fans two times respectively
  2. Put the Air gun close to the fan, be careful not to reach the grille or leaves inside as to prevent damage to the fan blades, blow each gap for 2-3 seconds, repeat 2-3 times.



Have more questions? Submit a request


Article is closed for comments.