Our miners are facing two major challenges as spring approaches.
- High poplar flutter
- The alternation of hot and cold, the temperature difference and the warm weather
Ant after-sales technical support has prepared the following treatment suggestions for your review.
I. Hazards and Prevention of Poplar and Willow Flurries
In fact, the time of appearance of willow flock varies from region to region, usually in March and April. In chronological order, they are burlap, willow and other poplars, such as small-leaved poplar and Canadian poplar. Beijing is dominated by burr aspen, and 80% of willow females will be mature by mid to late April for the peak season, which usually lasts about a week.
The danger of willow wadding: Willow wadding will be scattered in the air, because the mining machine fan heat needs a lot of air flow, willow wadding will be sucked into the mining machine, into the inside of the mining machine, because the radiator structure of the mining machine is tooth-shaped, willow wadding can not be discharged and hang on the radiator thus blocking the radiator. As a result, the miner cannot dissipate the heat smoothly, which will lead to repeated high temperature protection and even damage.
How to prevent: Increase the dust control net, dust control net should choose the fine wire, try to reduce the impact on the incoming air, when the dust willow reaches a certain amount, timely cleaning, can not affect the incoming air.
Regularly check the mine machine, you can observe the inside of the mine machine with the inlet fan. If there is willow and other gathering, you need to dismantle the machine to clean up. If the symptoms are mild, you can remove the front fan and clean it with a brush, or you can use an air pump to blow in reverse. If the blockage is serious, you can remove the machine to clean it, but pay attention to not mix the board.
*Note: All operations need to be powered off.
Ⅱ. The Hazards and Prevention of the Changeable Weather
This situation occurs mostly in the cold northern regions, and miners who run their machines in the northern regions during winter need to pay particular attention.
Hazard: Since the winter temperatures in the north are in the minus 10 degrees ~ 20 degrees. And the Spring Festival temperature began to rise back to 10~20 degrees, the winter temperature is low, basically do back to the temperature measures, such as reducing the amount of air intake, change the reverse of the mining machine, adjust the location of the mining machine. If you can't adjust back in time when the temperature rises quickly, it will lead to high temperature protection of the machine.
How to prevent: Adjust in time according to the temperature change, because in the excessive season of winter and spring, the temperature changes a lot and the temperature difference is big, the adjustment can not be adjusted at once, it should be adjusted several times, first adjust the upper layer. Pay attention to weather changes, keep the incoming air at night when the low temperature is not less than 5 degrees, and the temperature of the upper layer of the mining machine at noon when the high temperature is not higher than 35 degrees.
*NOTE: The high temperature protection of the mining machine is a means to protect the mining machine and should not be used as a constant. Frequent triggering of high temperature protection risks damage to the computing board.
Should you have any inquiries, feel free to contact us for assistance.
![]() |
Contact us > |
Comments
0 comments
Article is closed for comments.