L3+ virus cannot be removed?

已回答

关注

lukeizcool

• 2021年06月09日 01:55
• 已编辑于

Hello I seem to have virus described here, is there anything I can do? I tried reset button, ip locate button reset (factory), load firmware web interface, load firmware SD card (fails), and using bitmain AP miner tool V1.0.11 (picture of error below).

https://medium.com/hiveon/how-to-save-your-asics-breaking-virus-update-e2767d6888bf

 

 

When SD card is used (used 8gb card and official recovery image) it just blinks the red fault light. I think SD card recovery is blocked like the article above says. Article says sometimes only way is to replace the control board. I don't want to buy another control board because it has virus too! What can I do?

HELP Please!

0

• 正式评论

  

  Nick

  • 2021年06月09日 08:02

  Dear Luke

  Could you also try the below solutions ?

  Solution steps: 1. Insert the SD card with the upgrade file into the SD card holder of the A8 control board (the following figure shows the contents of the SD card) a) 2. As shown in the figure below, short circuit the two points, and then power on the control board. After 30 seconds, you can let go, and then wait for SD Card recovery NAND success

  评论操作 固定链接
• 

  Jerod Ellis

  • 2021年07月29日 21:39

  What kind of wire did you use to touch the two points together?

  0

  评论操作 固定链接
• 

  Nick

  • 2021年07月30日 08:03

  Dear

  Conductive copper wire is also OK

  0

  评论操作 固定链接
• 

  Yi Yang

  • 2021年09月10日 02:44

  Hello,

  It is a little unclear which pins to short. It looks like on the left, the second and first pin from the bottom, and on the right, the second and third one from the top? Can you please confirm if this is correct?

  0

  评论操作 固定链接
• 

  Daniel Dominguez

  • 2022年04月10日 19:16

  where can i find the l3+ sd recover NAND?

  0

  评论操作 固定链接
• 

  Linda

  • 2022年04月15日 02:29

  Hi, please go to this page to download the document you need

  https://service.bitmain.com/support/download

  0

  评论操作 固定链接

请先登录再写评论。