S19 stopped hashing, shows Inlet Temp / Outlet Temp 255 oC

评论

8 条评论

  • 正式评论

    Hi, if the problem still exits, please contact us at support-cs@bitmain.com to provide the updated kernel log.

    评论操作 固定链接

    Hi Kira

    Please check if the fans are running well,if not,please change new fans for it,if they worked properly,I suggest you to download the SD card recovery image to recover it and upgrade the latest firmware again,to see if the problem could be fixed.

    1
    评论操作 固定链接

    I have the exact same issue with 5 S19 Pro and S19. Out of the blue the hash rate drops to 0 and the temperature raises to 255C. I replaced the fans and the control board but the problem still persists. Could it be a damaged hashboard or temperature sensor?

    0
    评论操作 固定链接

    Kira T a_alnaser were you guys able to solve the problem? if yes... then how? please reply anyone.. 

    i am also getting "addrInterval or corenum is not initialized." 

    0
    评论操作 固定链接

    Similar situation here, however my fan 1 speed is out of wack reaching 30000! Any ideas here? Luke HAO-Technical Specialist 

    Thx

    0
    评论操作 固定链接

    any news here? i have the same issue, i have tested that the hash board is not over heating , so shuld be bad sensor, there is any procedure for replace it, or bypass the bad reading for avoid hashing interruption?.

    0
    评论操作 固定链接

    Hi, any news, i have just since yesterday the same issue. Fan is not damaged, but one fan show over 28000 rpms! Also run the latest firmware, just installed it again, but now change. Help is needed.

     

    0
    评论操作 固定链接

    Im having the same issue after 1 week with a s19apro. anyone selling intel miners?

    0
    评论操作 固定链接

请先登录再写评论。