S19j Pro 100T | Temperature showing 255 degrees in error

已回答

评论

5 条评论

  • 正式评论

    Dear

    The kernel log showed  ERROR_TEMP_TOO_HIGH

    Could you low down the temp and clean the dust according to the below firstly : 

    High temperature alert and protection

    https://support.bitmain.com/hc/en-us/articles/360008523893-High-temperature-alert-and-protection

     
    评论操作 固定链接

    BEWARE!

    DO NOT INSTALL the S19j Pro SD card recovery package.  It has BRICKED our miner!

    • Antminer-S19j-Pro-Release-sd2nand-zynq7007-20210605.zip (file size 26.87MB)
    • S19j Pro SD firmware for 7007 control board only (published 2021-08-26)

    This package is identical to the S19j package.  We have compared and match both packages' "update.bmu" file checksums.  Your miner will not be able to detect hash boards, reset to factory default firmware, or update to the Antminer-S19j-Pro-release-202106281212.bin firmware.  Effectively rendering your equipment useless.

    Bitmain support, please send the correct S19j Pro 100T (7007) recovery to niftyframes@protonmail.com

    1
    评论操作 固定链接

    Marcus, from my experience 255 errors are bad fans. You can check your kernel log and look at the fan speed to locate the fan that needs to be replaced

    1
    评论操作 固定链接

    Classic Bitmain support

     

    0
    评论操作 固定链接

    Dear Customer,
    If you have any questions please feel free to contact us.
    Please send email to customersupport@bitmain.com
    We will reply to your question as soon as possible.

    0
    评论操作 固定链接

请先登录再写评论。