S19a Pro read temp sensor failed: chain = 2, sensor pos = 79, address = 158, reg = 1
-
Dear customer.
From the kernel log,it shows PIC issue
please kindly exclude the issue by following steps:
1.Check the wires for the hashboard--pull them and re-plug them again, and also you can try to change the new wires.
2.Please clean up the dust.
How To Clean and Dust The Antminers
https://support.bitmain.com/hc/en-us/articles/115004520173-How-To-Clean-and-Dust-The-Antminers
3.Test for PSU failure
If there are still the same problems after the above steps, please send it to repair.
Best regards
-
Dear Customer,
If you have any questions please feel free to contact us.
Please creat support ticket by https://support.bitmain.com/hc/en-us/requests/new
Or send email to customersupport@bitmain.com
We will reply to your question as soon as possible.
请先登录再写评论。
评论
3 条评论