antminer IP issue

Answered

Comments

6 comments

    Hello!
    You can try to use the SD card to restore the control board to the factory, if there is still a problem, it may need to be repaired.

    0
    Comment actions Permalink

    I will try to upgrade it today but how can i use the sd card and upgrade it if the miner doesnt connect?
    is there a special way to do it without connection?

    how can it be damaged if it was new sealed from the box? and where can i get it repaired?

    0
    Comment actions Permalink

    the instructions are abit vague on the bitmain site

    can someone explain to me which files or folders i must place on the sd card?

    the site says download 2 files but only mentions on extracting 1 file to sd card and then doesnt mention if i must place it in a folder or just raw files..

    someone please explain to me the process step by step please

    0
    Comment actions Permalink

    hello

           You can refer to this document for operation.

    https://support.bitmain.com/hc/en-us/articles/115000216034

    0
    Comment actions Permalink

    as i explained in my previous comment these instructions are not clear

     

    for example

    1. Download the firmware to computer available here: https://service.bitmain.com/support/download

    what do i do with this firmware? i place it on the sd card or not?

     

    2. Download the installer program and unzip it: https://service.bitmain.com/support/download 

    is this the folder i place in the sd card or place the files inside the folder in the sd card?

     

    5. Copy the extracted file to the Micro SD card

    which files? step 1 or step 2 files?

    this is what confuses me so i need a beter step by step explanation to do this?

    should the miner have all wires attached to it or not? 

    which files exactly do i put in the sd card?

     

    0
    Comment actions Permalink

     

    Hello!
    Put the extracted files in the root directory of the SD card, as shown in the following figure

     

    0
    Comment actions Permalink

Please sign in to leave a comment.