S19 stopped hashing, shows Inlet Temp / Outlet Temp 255 oC

Comments

6 comments

    Hi Kira

    Please check if the fans are running well,if not,please change new fans for it,if they worked properly,I suggest you to download the SD card recovery image to recover it and upgrade the latest firmware again,to see if the problem could be fixed.

    1
    Comment actions Permalink

    I have the exact same issue with 5 S19 Pro and S19. Out of the blue the hash rate drops to 0 and the temperature raises to 255C. I replaced the fans and the control board but the problem still persists. Could it be a damaged hashboard or temperature sensor?

    0
    Comment actions Permalink

    Kira T a_alnaser were you guys able to solve the problem? if yes... then how? please reply anyone.. 

    i am also getting "addrInterval or corenum is not initialized." 

    0
    Comment actions Permalink

    Similar situation here, however my fan 1 speed is out of wack reaching 30000! Any ideas here? Luke HAO-Technical Specialist 

    Thx

    0
    Comment actions Permalink

    any news here? i have the same issue, i have tested that the hash board is not over heating , so shuld be bad sensor, there is any procedure for replace it, or bypass the bad reading for avoid hashing interruption?.

    0
    Comment actions Permalink

    Hi, any news, i have just since yesterday the same issue. Fan is not damaged, but one fan show over 28000 rpms! Also run the latest firmware, just installed it again, but now change. Help is needed.

     

    0
    Comment actions Permalink

Please sign in to leave a comment.