antminer d7 chip configure fail

Comments

8 comments

  • Official comment

    Hello, please configure mining pool for the miner.

    Comment actions Permalink

    Hello,

    I too am having the same problem.

    time="2022-01-14 01:04:32" level=notice pid=882 chain=0 msg="ChipSetting_get_addr_DASH detect 70 chips"
    time="2022-01-14 01:04:35" level=notice pid=882 chain=1 msg="ChipSetting_get_addr_DASH detect 30 chips"
    time="2022-01-14 01:04:35" level=error pid=882 chain=1 error="asic num error" msg="detected asic num less than design"
    time="2022-01-14 01:04:37" level=notice pid=882 chain=2 msg="ChipSetting_get_addr_DASH detect 70 chips"
    0
    Comment actions Permalink

    Hello, please configure mining pool for the miner.

     
    0
    Comment actions Permalink

    The mining pool is configured. Because the 2 working boards are currently hashing approximately 430 megahash each. The board that’s malfunctioned isn’t being recognized and not showing up at all in the Antminer miner page.

    0
    Comment actions Permalink

    Good morning, I have the same problem with 3 tables, only 2 work, is there a possibility to replace the broken table? Has anyone been able to solve it, LINDA does not give me a solution to the problem, greetings

    0
    Comment actions Permalink

    Hey Juan, I have the same thing going on with 2 D7s. I believe we have to send them back to Hong Kong and we have to pay for shipping. As I have to ship 2 of them I’m still working out the logistics on my end. Shipping from the US.

    0
    Comment actions Permalink

    Hey Martin, Woudn't it be better to send the broken table? if we send the full miner, there's a risk of it to be lost and there are also tax and dutties problems. Do you know how to send only the table? I have asked Linda and she hasn't answered me yet. Any notice I have I will communicate it to you. Regards.

    0
    Comment actions Permalink

    I had asked the same question and was advised to send the whole miner back to Hong Kong...

    0
    Comment actions Permalink

Please sign in to leave a comment.