Seeing a lot of hardware errors on new S19J pRO

Answered
Follow
John Gayeski

Am seeing a lot of errors and the following Warning on 3 new S19J Pro units:

 

nand: WARNING: pl35x-nand: the ECC used on your system is too weak compared to the one required by the NAND chip
Bad block table found at page 131008, version 0x01
Bad block table found at page 130944, version 0x01
8 ofpart partitions found on MTD device pl35x-nand

1

Comments

3 comments

Date Votes
  • Official comment
    Nick

    Dear

    Could you send us full kernel log after the miner running 20-30 mins , after double checked we will advise you the solutions and advice.

    Kernel log will always show the real reason issue for the antminer.

    https://support.bitmain.com/hc/en-us/articles/360016522253-How-to-copy-Kernel-Log-into-text-form

    Comment actions Permalink
  • Nifty Frames

    BEWARE!

    DO NOT INSTALL SD card recovery package below.  It has bricked our S19j Pro 100T.

    • Antminer-S19j-Pro-Release-sd2nand-zynq7007-20210605.zip (file size 26.87MB)
    • S19j Pro SD firmware for 7007 control board only (published 2021-08-26)

    This package is identical to the S19j package.  We have compared and match both packages' "update.bmu" file checksums.  Your miner will not be able to detect hash boards, reset to factory default firmware, or update to the Antminer-S19j-Pro-release-202106281212.bin firmware.  Effectively rendering your equipment useless.

    Bitmain support, please send the correct S19j Pro 100T (7007) recovery to niftyframes@protonmail.com

    1
    Comment actions Permalink
  • Joseph Sleiman

    Hello I am having a lot of hardware errors as well.  I am averaging 100 errors for each board in 24 hours. 

     

    0
    Comment actions Permalink

Please sign in to leave a comment.

Didn't find what you were looking for?

New post