My Bitmain T17 lost Hashboard number 2

Answered

Comments

5 comments

  • Official comment

    Dear

    Some asic can not be detected all .please try the below firstly.

    1 Clean the dust for the antminer: How To Clean and Dust The Antminers https://support.bitmain.com/hc/en-us/articles/115004520173-How-To-Clean-and-Dust-The-Antminers

    2. Flash the SD card program to recover the control board.

    3 Reboot the antminer to try.

    Comment actions Permalink

    Dear

    Please also check the wire line for the hashboard,- unplug and plug them again to test.,

    0
    Comment actions Permalink

    Hi Jessica,

    1. I did flash the SD card with T17 program from your previous posted. Same problem

    2. I open the controller clean all dust and checked wire. Same problem

    3. I swap the cable from controller board from port 1 to hasboard 2, then I swap the cable from port 2 to hashboard 1. After reboot the miner detected board 2 but board 1 not show. Please see the photo then advise me again.

    Regards

    0
    Comment actions Permalink

    Dear

    Please Check the wire line for the hashboard,- unplug and plug them again to test.,

    0
    Comment actions Permalink

    Yes I did all that  but 1 hashboard are missing. Any other way or advise please

    0
    Comment actions Permalink

Please sign in to leave a comment.