If it is not necessary, the miner does not need to be powered off. The miner is designed for long-term operation. There is no power switch or shutdown button. The power-off method is to cut off the power.
If you must power off, keep the following two points in mind:
- Do not turn off the miner in a high humidity environment, because it generates a lot of heat. After the miner is turned off, the temperature will drop due to condensation and moisture, which will corrode the circuit for a long time.
- Do not directly turn off the main circuit breaker, and power off one by one in an orderly manner. Due to the high power of the miner, batch power outages will cause the instantaneous impact of voltage surges to damage it.
When the miner is disconnected from the network, it will automatically reconnect to the network, and after a certain number of reconnections, it will automatically shut down for protection.
- The miner will be shut down for protection after a long-term disconnection. At this time, the miner is the same as the power outage, and the temperature of the miner changes greatly. If the miner is in a high-humidity environment, it is prone to corrosion due to condensation. After the network is disconnected, the miner cannot mine normally, but it still consumes electricity. When the expected disconnection time exceeds 15 minutes, the power should be cut off directly.
- When you plan to cut off the network, you should cut off the power first, and then cut off the network.
Should you have any inquiries, feel free to contact us for assistance.
|Contact us >|