Attention: the following instruction only applies to fixed-frequency miners such as DR5 and D5. If your miner is auto-frequency (e.g., S11, S15,T15), we need to receive the complete unit for repair because we cannot guarantee the miner will work well with the repaired board unless we test the complete unit in our facility.
- Cross screwdriver (4mm diameter)
- Hexagon screwdriver (3mm diameter)
- A pair of gloves for protection purpose
1. Dissemble the control board case.
Place the miner as shown in the picture below. Use the cross screwdriver to remove the 6 screws.
Unplug all the cables. See the red arrow signs in the picture below.
Remove the 14 screws.
Remove the PSU metal pieces.
Lift up the control board part and remove it.
2. Dissemble the hashboards.
Remove the 4 screws in the back metal board.
Pull the hashboards out.
If you are still not clear of the instructions, contact us for further assistance.
|Contact us >|