D3 Hash rate is low or a hash board is faulty




  • giorgi skhiladze

    my antminer d3 problems. One has boarded a high temperature. what should I do?  I have a guarantee From Bitman 6 Month

  • Arif Hidayatullah4545

    problem antminer D3 chain #2 missing 


    kernel log status asic chain1 0 ASIC

    help me

  • Dani Daod

    I have problem too in the chain i miss tow what i should do 

  • R A

    I have the same problems, I have at least 10 D3 miners with missing chains.

    I flashed latest firmware.

    I tested each board individually. 

    One miner showed all 3 back then at some point disappeared again. 

    I don't know what's happening.

  • Q Chaud

    I am having a similar problem with D3 and in addition, it stops mining ... and i need to restart every 3 hours.


    pls help ...

  • Jesus Spinetti

    I have the same problem, 

    I have at least 10 D3 miners with missing chains.

    I flashed latest firmware.

    and i need solutions

  • zsposeidon

    Same problem here. 28 units running at 2 different sites.
    Firstly I see some still active, but today all went offline (both site simultaneously).
    Some miner are hashing but antpool show disabled. Was there other report of pool issue? Will also file support ticket with details. 

    Secondly for past week need reboot 50% or machine every few hours. Some showing less hash card then others aka 2 chains with or xxxxx on chips.  I checked that all my machine not on latest FW will flash and check again. Will leave an open support ticket till resolved. Thanks!  

    It will Be nice if customer can be notified of releases of FW  


  • Lukejtilley

    I have the same problems, I have D3 miners with missing chains or a single "x" and then I reboot and it shows another error i.e. missing columns in ASIC status.

    I have e-mailed several times and had nor reply with a solution.

    I updated latest firmware but still errors are occurring.

    I have also had payments which are showing as being paid withdrawn and NOT paid.

    I have sent several screen shots.

    I don't know what's happening.

Article is closed for comments.