This method applies to all ANTMINERs.
To power off/shut down a miner:
As the mining machine is directly powered by the power supply, there is no switch, so the mining machine can be turned off directly on the vac or unplug the 220V input line of the power supply.
Note*: APW12 power supply has two power lines, try to power on or off at the same time, if you can't do both power lines at the same time, you should plug in the outer power line first, then plug in the inner power supply when you power up the machine. When the machine is disconnected, first off the power line against the inside, and then off the power line against the outside.
To restart/reboot a miner:
There are two ways to restart the miner;
first is to power off the miner and then power on again.
second is to backend restart
- Series 17:click “Reboot” in the miner user interface as below.
Miner backstage > System > Reboot
- New firmware versions such as 19 series：in the bottom right corner of the background screen, click on "Restore factory settings".
Should you have any inquiries, feel free to contact us for assistance.
|Contact us >|
The proper way to shutdown an antminer is to connect to it using ssh and enter the command `poweroff`. The fans won't stop but after a few minutes you will notice that the miner cools down and then you can securely unplug it
Article is closed for comments.