This method applies to all Antminers.
To power off/shut down a miner:
As the miner is directly connected with the PSU and there is no hard switch on the miner, all you need to do is to pull the PSU power plug (by pulling the plug, not the cord) to disconnect the power.
To restart/reboot a miner:
There are two ways to restart the miner; first is to power off the miner and then power on again; the second is to click “Reboot” in the miner user interface as below:
Miner backstage > System > Reboot
If you are still unable to solve this problem, contact us for further assistance.
![]() |
Contact us > |
Comments
1 comment
The proper way to shutdown an antminer is to connect to it using ssh and enter the command `poweroff`. The fans won't stop but after a few minutes you will notice that the miner cools down and then you can securely unplug it
Article is closed for comments.